Bulk Aggregates for Patios in Resaca, GA

Georgia Rock Supply handles gravel and aggregate delivery in Resaca, GA, and most of the calls we get here start the same way: a patio or a paver walkway going in over ground that will not stay put. The fix is almost always in the base. Graded aggregate base, called GAB around here, is the material that carries the load under pavers and flatwork.

Resaca sits on valley floor ground in Gordon County, where clay and loam hold water after a ridge storm. That changes what you order and how deep you put it.

Materials for Resaca Projects

On a patio job, the base does the work and the pretty stone on top just finishes it. Get the bedding layer right and the pavers stay flat for years.

Start with GAB (Graded Aggregate Base). It is the standard Georgia base, and it compacts into a hard, tight plate that spreads the weight of a patio or a parking pad. On clay, that plate is what keeps the slab from pumping and rutting.

Over the compacted base, the bedding layer sets the pavers. Screenings, also called granite screenings or granite dust, are the material for paver and flagstone bedding and for leveling under pavers. Screened fine and consistent, they rake to a true plane and lock the units in place.

Where you want a base that binds as it compacts, Crusher Run is the pick. It is used for driveways and for base under pads and patios where a compacting, binding material is wanted. The fines work into the voids and the surface tightens up.

For drainage around the patio edge or behind a low wall, #57 Granite is the usual choice. Georgia #57 is Crushed Stone, and it goes into French drains, drainage behind walls and driveway topping.

Small stone has its place too. #89 Crushed Stone works for walkways, paths, paver joints and tight bedding where #57 is too coarse to sit right. Mason Sand handles brick and block work, paver joints and play sand.

Ground and Conditions in Resaca

Here is the failure you see on a thin base in this county. The patio looks fine for a season, then a corner drops and the joints open up. Water got under it and the clay underneath could not hold.

Valley floor ground in this part of Gordon County is clay and loam over limestone and shale. Clay sheds water slowly, so rain that runs off the ridges sits in the flat ground and softens it. A base that is too shallow rides on that soft layer instead of bridging it. The fix is depth and compaction: excavate enough, put down graded aggregate base in lifts, and compact each lift before the next one goes on.

Drainage is the other half. Where limestone lies underneath, water can move underground through sinkholes and caves, so a patio that sheet drains toward a low spot may still stay wet. A #57 Granite drainage layer at the edge gives the water somewhere to go.

Runoff from the ridge slopes also scours ditches and creek banks, and bare clay washes easily in heavy rain. If your project disturbs a slope, plan on rip rap or a stone-lined outlet before the first big storm, not after.

Timing matters as much as material. Long wet spells in winter and spring leave valley clay soft, and a cold snap with ice or snow can briefly stop work. Winter brings regular freezing nights, but frozen ground seldom lasts long here. Frost depth is shallow, and the Georgia residential code sets a 12 inch minimum footing depth. Base depth on this ground is carried by wet clay and drainage, not by frost heave.

Delivery to Resaca and the Surrounding Area

Order online and pick your material by the ton or by the yard. Bulk stone and base are usually sold by the ton, while sand, topsoil and mulch are often easier to figure by the cubic yard. If you know your square footage and how deep the layer goes, you can convert between the two and land on a number that matches what the truck brings.

Estimate in two steps. First, area times depth gives you volume. Second, multiply by the weight per yard for that material, because a yard of GAB and a yard of mulch do not weigh the same. Round up a little, since compaction pulls the base down and a short load costs you a second trip.

We deliver bulk loads to jobs in Resaca and to the rest of Gordon County, including Calhoun, Fairmount, Plainville, Ranger and Sugar Valley. Tell us where the truck can back in and where you want the pile dropped.

Questions About Gravel and Base in Resaca

What gravel is best for a driveway in Resaca?

For most drives here, start with graded aggregate base, called GAB, compacted in lifts. It is the standard Georgia base material and it holds up on clay. Top it with crusher run or driveway gravel for a tight running surface, and use #57 granite in any drainage run along the edge. On a new drive, a first course of #4 crushed stone helps carry heavy loads.

How much material will my project need?

Measure your square footage and the depth you want, then let the calculator convert it to tons for that specific material. A patio base adds up quickly, so enter your square footage and depth to see the volume before compaction. Add a little extra for settling and spillage, and round up rather than short.

Get Your Patio Base Figured Out

Use the calculator on the site to turn your patio dimensions into tons or yards, and check the depth against the clay ground you are building on. When you have your numbers, order graded aggregate base, screenings and drainage stone for delivery in Resaca and we will get the load to your site.